Iron man mark 42 helmet might be too big, need help

I need feedback on this guys, I sized the helmet to fit my head exactly, the width was, from what I remember, 195 mm on pepakura designer 3. After fiberglassin and bondoing ( iv'e gotten so far on this build because I haven't had time to try it on untill now, without vlacking out due to the fumes of course, and I fear that the helmet might look a tad bit big. I just need feedback from you guys to tell me if it look ok size wise or if its proprtionally too big. I personally think it look a bit big although having the insight of others would help :D

By the way, the helmet fits exactly width wise but there is probably half an inch from my chin to the chin of the helmet and around one or two inches from the back of the helmet, I even had to remove the back piece (which will eventually go back suing a hinge) to fit my head through since the opening was too small.




- - - Updated - - -

I don't understand why the pictures are upside down, sorry :facepalm

Attached Thumbnails